Tabla de contenido
GB
English
4) place the cover back on the battery compartment.
5) screw the screw in the cover.
Extract the batteries and dispose them as special waste at the specific collection
points forecast for recycling.
For more information about the disposal of run down batteries, please contact
either the store where the device containing the batteries was purchased, or the
Municipality, or the waste disposal local service.
Caution: For greater safety, children younger than 12 years shouldnot
remove the batteries.
INSTRUCTIONS FOR A CORRECT USE
MEASUREMENT OF THE FOREHEAD TEMPERATURE (HEAD)
1) Make sure that the probe is clean and integral.
2) Clean the temple where the probe will lean.
3) Switch on the thermometer, by pressing the key "ON/MEM".
On the display appear all the function symbols (self-test); after few seconds,
the display shows the message "HEAD-°C" and emits two beeps. At this point,
the thermometer is ready for use.
4) Lean the probe on the right or left temple; press the key "SCAN" and keep it
pressed, then slowly move the probe around the temple. The thermometer emits
beeps indicating that the measurement is taking place.
5) A longer and more intense acoustic signal indicates that the measurement has
ended (Time necessary to perform the measurement ranges from 5 to 30 second
according to the temperature of the person).
Should the temperature exceed 37.5°C, the thermometer emits a long beep
followed by other three shorter beeps.
6) Release the key "SCAN" and then detach the probe from the temple; read the
measured value on the display
INFRARED FOREHEAD THERMOMETER
Important: the temperature shown on the display is equal to the oral
temperature, i.e. temperature measured on the forehead is translated as if it
were measured in the mouth.
7) The device switches off automatically after 1 minute, if it is not used.
MEASUREMENT OF THE ROOM TEMPERATURE ( )
This thermometer allows the measurement of the room temperature.
1) Switch on the thermometer, by pressing the key "ON/MEM". On the display
appear all the function symbols (self-test); after few seconds, the display shows
the message "HEAD-°C" and emits two beeps.
2) Keep the key "ON/MEM" pressed and then press the key "SCAN".
The display shows the icon " " (HEAD disappears).
3) If you wish to measure the temperature on a precise point, press the key
"SCAN".
The thermometer measures the temperature in 0.6 seconds.
If the "SCAN" key is kept pressed, temperature is updated continuously.
4) The device switches off automatically after 1 minute, if it is not used. When it is
switched on again, the display shows the forehead temperature measurement
function (HEAD).
CELSIUS/FAHRENHEIT
This thermometer can measure temperature both in Celsius and Fahrenheit degrees.
Each time you wish to change the measurement unit, proceed as follows:
1) With switched off thermometer, keep the key "SCAN" pressed without releasing
it for some seconds, and then press contemporaneously the key "ON/MEM"
until the displays shows °F (or °C).
2) The thermometer emits two beeps; at this point, release the key "SCAN" and
the key "ON/MEM".
18
Tabla de contenido
