Chicco GO ONE Manual Del Usuario página 29

them towards you to release them (diag. 16).
- release the restraint harness, pressing the red
button on the buckle (Diag. 17).
- open the fabric cover velcro fastener on the inte-
rior of the backrest (Diag. 28).
- push the harness strap, together with the shoul-
der strap, under the cover (Diag.29).
- repeat this procedure for the other strap.
- remove the headrest cover, the crotch strap and
the child car seat cover.
To replace the fabric cover and safety harness,
proceed as follows:
- replace the headrest cover, the crotch strap and
the child car seat cover.
- before closing the velcro fasteners, thread the
restraint straps over the fabric cover (Diag. 30).
ATTENTION! Check that the harness straps are not
twisted.
ATTENTION! The fabric cover on some versions is
fitted with a zip instead of Velcro fasteners.
Cleaning the plastic and metal parts
Clean the plastic or varnished metal parts using
only a soft, damp cloth.
Never use abrasive detergents or solvents.
The child car seat moving parts must never be
lubricated.
Inspecting the condition of components
It is recommended to regularly check the condi-
tion of the following components for any wear
and tear:
• Fabric cover: check that the padding has not
been torn out or is bursting out of the seams.
Check the condition of the seams: they must
always be completely secure.
• Straps: check that there is no irregular wear
and fraying of the woven straps, with evident
thinning out of adjustment strap thickness, or
of the lap harness strap, the shoulder straps, as
well as in the area of the belt adjustment plate.
• Plastic parts: check all plastic parts for wear
and tear, damages or fading.
WARNING! In the event that the child car seat is
evidently deformed or very worn, it must be re-
placed: it may no longer conform to the original
safety standards.
Storing the Product
When it is not fitted into the car, it is recommend-
ed that the child car seat is stored in a cool, dry
place, far from heat sources and dust contamina-
tion, as well as humidity and direct sunlight.
WARRANTY
The product is guaranteed against any conform-
ity defect in normal conditions of use as provided
for by the instructions for use.
The warranty shall not therefore apply in the case
of damages caused by improper use, wear or ac-
cidental events.
For the duration of warranty on conformity de-
fects please refer to the specific provisions of na-
tional laws applicable in the country of purchase,
where provided.
29