Tabla de contenido
1. Hose to Tank
1A
Make sure white outlet
tube is attached to hose.
4
1D
Line up tabs on safety lock
connector with notches on
the outlet flange of the tank.
Insert tabs into notches to
form a secure seal.
2. Assembly of Shut-off, Extension Wand and Nozzle
2a
Shut-off Assembly
1) Screw nozzle assembly onto threaded end of the extension wand securely.
2) Insert unthreaded end of extension wand into shut-off assembly as shown and tighten retaining
nut securely.
Nozzle Assembly
Figure 1-2
Unscrew the nozzle cap (1) from the nozzle body (3) with retaining nut (2) fastened tightly to the elbow (5). Unscrew the
retaining nut (2). Push the nozzle body (3) with the nozzle gasket (4) out of the retaining nut (2). To reinstall the nozzle,
reverse the above instructions.
Figure 3
Unscrew the retaining nut from the elbow and push the fan nozzle tip and gasket out of the retaining nut. To reinstall the
nozzle, reverse the above instructions.
3. Filter
The filter helps prevent clogging while spraying. It is located on the end of
the white tube inside your sprayer tank.To clean filter, remove the hose from
the tank and lift out the outlet tube. Make sure the filter is positioned at the
bottom of the tank as pictured.
1B
Insert tube into
tank.
1E
Slip hose nut down to tank,
turnclockwise and tighten as
tight as possible by hand.
Retaining Nut
1C
Proper placement of
white outlet tube.
Extension Wand
Nozzle Assembly
3a
Filter
Tabla de contenido
