Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4.1) Programming the transmitters
Each radio control is recognised by the receiver incorporated in the MOVENO DSRCE-V control unit through an individual "code" that is unlike
any other. The control unit must therefore be programmed to recognise each separate radio control through a "memorisation" process.
When the memory does not contain any code, you can proceed to program the first radio control by operating as follows:
Table "A1"
Memorizing the first transmitter (in Mode I)
1.
Connect the motor to the power supply, 2 long beeps will be heard immediately.
Within 5 seconds press and hold button ■ of the transmitter to be memorized
2.
(for approx. 3 seconds).
Release button ■ when you hear the first of the 3 beeps confirming memorization.
3.
See table A2 for the memorization of additional transmitters.
When one or more transmitters have already been memorized, others may be enabled as shown in table A2.
Table "A2"
Memorizing additional transmitters (Mode I)
Press and hold down button ■ of the new transmitter (for approx. 5 seconds)
1.
until you hear a beep then release it.
Press button ■ of a previously memorized transmitter slowly 3 times.
2.
Press button ■ on the new transmitter again. Release button ■ when you hear the
3.
first of 3 beeps, signalling that memorization has been carried out.
Note: If the memory is full (14 transmitters), 6 beeps will indicate that the transmitter cannot be memorized.
4.2) Programming of positions "0" and "1"
A remote control memorised in Mode I must be used to program the positions. The manoeuvres will remain hold-to-run until positions "0" and
"1" have been memorised in the control unit. To begin with, the direction of the motor is not defined but after point 1 in table A3 has been
completed the direction of the motor is automatically assigned to the remote control buttons.
Follow the procedure in table A3 to program the "0" and "1" positions:
Table "A3"
Programming of positions "0" and "1"
Press and hold buttons ▲ or ▼ of a memorised remote control until the awning is fully
1.
closed and the motor automatically stops.
Press and hold button ▼ that lowers the awning.
2.
Release button ▼ when the awning is in the desired position ("1").
3.
If necessary use the ▼ and ▲ buttons to adjust the position.
Press and hold button ■ of the transmitter until you hear a beep
4.
(after about 5 seconds) then release it.
Release and press again button 5 for another 5 seconds until ■ rapid beeps are heard.
5.
Press button ▼ until 3 beeps are heard and a short up and down movement occurs
6.
indicating that the position has been memorised.
4.3) Optional programming
All optional programming is only possible after the "0" and "1" positions have been programmed.
www.stobag.com
Example
3s
Example
New
5s
Old
X3
New
Example
5s
5s
GB
29
Tabla de contenido
