Bosch SHU42L Manual Del Usuario página 11

c ) Remove the spray arm as shown in
Figure 18.
Figure 18
d ) Look for obstruction in the spray
nozzles.
e ) If the spray nozzles need cleaning,
flush them under running water.
- To reinstall the top spray arm:
f ) Return the top spray arm to its
installed position.
g ) Return the locking nut to its
installed position and turn it 1/8 turn
clockwise.
h ) Return the top rack to the top rack
roller guides.
- To remove the bottom spray arm:
i ) Remove the empty bottom rack from
the dishwasher tub.
j ) Grasp and lift the bottom spray arm
as shown in Figure 19.
Figure 19
k ) Look for obstruction in the spray
nozzles.
l ) If the spray nozzles need cleaning,
flush them under running water.
- To reinstall the bottom spray
arm:
m ) Return the bottom spray arm to its
installed position and press it so that it
snaps into place.
n ) Return the bottom rack to its
installed position.
CARE AND MAINTENANCE
5. Check/Clean the Filter System
Your Bosch dishwashers has a filter
system that is made up of a Large
Object Trap/Cylinder Filter assembly
and a Fine Filter. The filter system is
located on the dishwasher floor and is
easily accessble.
During normal use the filter system is
self-cleaning, but you should
occasionally inspect it for foreign objects
and clean it when necessary.
- To Remove the Large Object
Trap/Cylinder Filter Assembly:
a ) Remove the bottom rack.
b ) Grasp the assembly as shown in
Figure 20, and turn it counter-clockwise
1/4 turn.
Figure 20
c ) Lift out the assembly as shown in
Figure 21.
Figure 21
C A U T I O N
INJURY HAZARD:
The large object
trap could contain sharp objects. Do
not reach into the large object trap
with your fingers.
d ) Carefully examine the assembly. If
you find debris in the Large Object Trap,
turn it upside-down and gently tap it on
a surface such as a countertop to
dislodge and remove the debris. Flush
the Cylinder Fliter clean by holding it
under running water.
- To Remove the Fine Filter:
e ) Lift the Fine Filter from the
dishwasher floor as shown in Figure 22
and flush it clean by holding it under
running water.
Figure 22
- To reinstall the filter system:
f ) Return the Fine Filter to its installed
position
g ) Place the Large Object Trap/Fine
Filter Assembly into its installed position
in the dishwasher floor.
h ) Turn the ring handle clockwise 1/4
turn until it is locked. The arrow on the
ring handle and the arrow on the Fine
Filter should point to each other, as
shown by the circle in Figure 23.
Figure 23
i ) Gently pull the ring handle to ensure
that the Assembly is locked into place.
9