Example Of Installation On The Floor Mat Or On The Chassis; Replacing The Top Cover - Pioneer PRS-D4200F Manual Del Usuario

Installation
Example of installation on the
floor mat or on the chassis
1. Place the amplifier where it is to be
installed. Insert the supplied tap-
ping screws (4 mm × 30 mm) into
the screw holes. Push on the screws
with a screwdriver so they make
marks where the installation holes
are to be located.
2. Drill 2.5 mm (1/8 inch) diameter
holes at the point marked, and
install the amplifier, either on the
carpet or directly to the chassis.
15

Replacing the top cover

1. Align the unit and top cover, and
insert the screw.
• The cover can be installed in the desired
direction to match to the amplifier.
2. Tighten the screw with a 4 mm
hexagonal wrench.
Tapping-screws (4 mm × 30 mm)
Screw
Drill a 2.5 mm diameter hole
Floor mat or chassis
Top Cover