Seko TWINDOSE 20 Manual De Instalación página 9

3.3
Connect the rinse solenoid valve to the RINSE connector and the load solenoid valve to the
CHARGE connector (see Picture5). Set the jumper J4 to OFF
Getting Started
Installation
3.3.1
When the rinse solenoid valve is on, both pumps will work at the set speed.
SET UP &
To adjust the detergent pump speed use the trimmer SPEED DET ( 15-100% ).
OPERATION
To adjust the rinse-aid pump speed use the trimmer SPEED RIN ( 15-100% ).
Led 1 is green and flashing.
Led 2 is green and flashing.
Maintenance &
3.3.2
Accessories
When the load solenoid valve is on, the detergent pump will dose for the set time with a delay
time of 60 seconds, working at the maximum speed.
Troubleshooting
To adjust the detergent pump dosing time use the trimmer TIME DET ( 0-200 seconds  5% )
.
Led 1 is green and flashing during dosing, when the dosing is over it turns red.
Contacting SEKO
3.4
To prime, press the left PRIME key for the detergent pump, and the right PRIME key for the
rinse-aid pump. When the keys are released the system will return to its previous condition.
Priming can be activated only when the solenoid valve is ON
TWINDOSE 20
CONVEYOR WAREWASHING MACHINES
J4
Rinse cycle
First charge
PRIMING
Led 1
DETERGENT
PUMP
PRIMING
Rev. 1.4
1 2 3
cod. 0000136325
Led 2
RINSE-AID
PUMP
PRIMING
8