Maintenance And Periodic Verification; Battery Replacement; Other Verifications; Transport And Storage - Tractel dynafor Industrial Serie Manual De Instalación, De Utilización Y De Mantenimiento

• Using the product if there is a risk that it may be
subjected to compressive, bending or torsional loads.
• Preventing the product being aligned in the line of
force.
• Using the product in a highly corrosive environment.
• Using the product in an explosive environment.
• Using the product outside the temperature range of
-20°C to 50°C.
• Using the product if it has been subjected to a force
above 110% of its SWL.
• Before use, failing to observe the stabilisation time
(20-30 minutes) of the product after a sudden change
in temperature.
7. Maintenance and periodic
verification

7.1. Battery replacement

The battery indicator light flashes when the batteries
are low. They need to be replaced.
• Using a Philips screwdriver, remove the battery
compartment cover.
• Replace the two "AAA" 1.5 V batteries with new ones,
minding the polarities.
• Put back the battery cover and tighten the fixing
screws so that the cover is flush with the edge of the
battery compartment.

7.2. Other verifications

Tractel recommends periodically inspecting the
®
appearance of the product and cleaning the sensor
regularly with a dry cloth.
Tractel also recommends annual recalibration (for
®
adjustment see section 3.1Presentation) before the
valid certificate expires.
Tractel can provide these services on request.
®

8. Transport and storage

During storage and/or transport, the product must be:
• Packed in its original packaging with the batteries
removed
• Stored in a dry location
• Stored at a temperature between -20°C and 60°C
• Protected from chemical, mechanical or any other
type of attack.
9. Product disposal and environmental
protection
The product must be disposed of in accordance with the
regulations applicable in the country of use.
The product complies with the requirements of the
REACH regulation and the RoHS directive; it is not
covered by the WEEE directive.
The different product components must be recycled on
the basis of the table below, after separating metal and
synthetic materials. These materials must be recycled
by specialist organisations.
At the time of disposal, only trained individuals may
dismantle the product to separate its components.
Component
Product body
Electronic housing (plastic)
Printed circuit board and
display
Batteries
Tractel can recycle the product. Please contact
®
Tractel for more information.
®

10. Technical specifications

Description of the integrated display on the front panel.
See figure 2.
A Measured value
B Measurement sign
C Net indicator (net measurement value)
D Gross indicator (gross measurement value)
E Peak load indicator
F Battery indicator
G Pounds unit indicator
H Kg unit indicator
I daN unit indicator
J Decimal point
To be treated as a
waste of the type
Aluminium
Ordinary waste
Electronics
Accumulator
11
GB