Associated Equipment; Uses; Installing The Batteries; Installation - Tractel dynafor Industrial Serie Manual De Instalación, De Utilización Y De Mantenimiento

E T2 Tare Button
F T1 On/Off button
G Product make
H Sensor body
I
Shackle bore
J
LCD screen
K Manufacturer's name
L Battery compartment cover
M Cover fixing screw M
All indications and labels affixed on the product
by the manufacturer must be kept fully legible. If any
indications and labels are removed or damaged, they
must be replaced before continuing to use the product.
Tractel can supply new marking materials on request.
®

4. Associated equipment

The product is compatible with the following equipment:
Lifting accessories:
• Bow shackle
• Swivel hook under load
dynafor™ Bow shackle
Industrial 1t 47916
Industrial 3.2t 47916
Industrial 6.3t 47926
Industrial 12.5t 47936
Industrial 20t 47946
For details of lifting accessories, please refer to the data
sheets and illustration of swivel hooks in figure 5.

5. Uses

The supervisor must ensure that a technician is
tasked with installing the product. The supervisor must
ensure that the operator has reviewed this installation,
operation and maintenance manual before they use the
product.

5.1. Installing the batteries

The two 1.5 V "AAA" batteries are factory installed.
Remove the insulating tab protruding from the battery
compartment to activate the batteries. For subsequent
battery replacement, please refer to section 7.1

5.2. Installation

During installation, it is absolutely necessary to:
1. make sure that the load line anchor point or points
are sufficiently strong for the force that will be applied.
2. make sure that the lifting accessories at both ends
of the product are compatible and comply with
applicable local regulations.
3. correctly lock the shackles by screwing their pin in
fully and make sure that the hook safety catch is
present and in good working order.
4. Allow the product to line up freely in the line of force.
5. Check the presence and condition of the batteries
in the sensor.
Use the product only with tensile force.
Check that the product has a valid calibration certificate.
The product may be used in all directions, including
horizontally.
The product works satisfactorily in a temperature range
of -20°C to +50°C. For use beyond those temperatures,
the product must have thermal protection.

5.3. Starting up

To start the product, press the on/off button for 1 second
Swivel hook
(ref. F, fig. 1). five different screens will then be displayed
40977 (type A)
successively in the following order (see figure 7):
40977 (type A)
Reference
105567 (type B)
113227 (type C)
105587 (type C)

5.4. Functions

5.4.1. Automatic zeroing

When the dynafor™ Industrial is switched on, the
display will show "0" providing the measured force is
less than 10% of the SWL of the product.

5.4.2. Tare function

The Tare function is used to indicate the net force of
the load.
Description
A Digit control
B SWL
C Program version
Date of last calibration
D
(mm - yy)
E Measurement in progress
GB
9