Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
ACCESSORIES
Parallel guide
Hex key
Vacuum adapter
24T TCT Blade (WA5100)
HCS Blade (WA8302)
Abrasive cutting disc (WA5048)
We recommend that you purchase your accessories
listed in the above list from the same store that sold
you the tool. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
WARNING:
Do not release the handle until the saw blade
come to complete stop and do not touch saw blade
while the saw blade is running.
INTENDED USE:
The tool is intended for ripping and cross-cutting
wood and other materials in straight cutting lines,
while resting firmly on the work piece.
Compact Circular Saw
ASSEMBLY AND OPERATION
Action
Mounting and Removing the Blade
NOTE: Lock or loose the blade
bolt, the spindle lock button
should be pressed.
WARNING: Always
remove the battery before
changing the blade!
Safety switch and On/Off trigger
WARNING: To avoid
cutting injury from the
sharp blade, please don't put
your hands around the Base
Plate.
NOTE: Keep the dust adapter
connected to dust collecting
device when using the tool.
1
Rip and Cross Cutting
1
NOTE: The cutting line of saw
blade is aligned with the cutting
1
mark 0°.
1
Parallel Guide
1
Adjusting the Cutting Depth
1
Adjusting the Cutting Angle
NOTE: The cutting line of saw
blade is aligned with the cutting
mark 45°.
Pocket /Plunge
Sawdust Removal
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the
motor. Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock. Cutting
with extreme force can significantly reduces the
performance capability of the tool and reduces the
service life of the saw blade. Sawing performance
and cutting quality depend essentially on the
condition and the tooth count of the saw blade.
Therefore, use only sharp saw blades that are suited
for the material being cut.
Choice of blades: 24 teeth for general work, approx.
40 teeth for finer cuts, more than 40 teeth for very
fine cuts into delicate surfaces, diamond for tile,
cement board, etc.
Only use saw blades recommended.
Figure
See Fig. A
See Fig. B
See Fig. C1, C2
See Fig. D1, D2
See Fig. E1, E2
15
See Fig. F
See Fig. G1, G2
See Fig. H
EN
Tabla de contenido
