Festool SYS-PST 1500 Li HP Manual De Instrucciones Original página 23

1 > LED < 8 flash red
No fault indicator and consumer cannot be operated
Ensure that transport mode is deactivated: Set the transport switch [1-13]
to "I".
Ensure that the on/off switch [1-7] is switched on (see section 7.3) and the
LED indicator [1-9] lights up green.
If LED 1 flashes green, SYS‑PST 1500 Li HP is almost completely discharged
Charge SYS‑PST 1500 Li HP (see section 7.2).
Try to operate SYS‑PST 1500 Li HP again.
If no consumer can be operated, contact the manufacturer or service work­
shop (see section 10).
SYS‑PST 1500 Li HP does not charge
Ensure that transport mode is deactivated: Set the transport switch [1-13]
to "I".
Connect the charging cable [1-11] to the AC charging input [1-1] and mains
outlet.
If SYS‑PST 1500 Li HP still does not charge, contact the manufacturer or
service workshop (see section 10).
8 Storage
► Unplug the consumer.
► Remove the charging cable [1-11]
and store it in SYS‑PST 1500 Li HP.
► Activate transport mode: Set the
transport switch [1-13] to "0".
► Close the Systainer lid with the T-
Loc [1-5].
Systainer lid with T-Loc [1-5] and/or place
SYS‑PST 1500 Li HP in a cooler location.
The charging process automatically re­
starts after cooling.
System error
Switch off (see section 7.3).
Remove the charging cable [1-11] and
store it.
Activate transport mode: Set the trans­
port switch [1-13] to "0".
Contact the manufacturer or service
workshop (see section 10).
► Close the protective cap on the AC
output [1-2].
► Do not store in a discharged state
for long periods of time. This can
lead to deep discharge and require
recommissioning by the manufac­
turer.
English
23