Installation; Dil Switch Settings - Danfoss TP7000 Range Guia De Instalacion

3.0 Installation

First remove the wallplate from the back of the unit.

From the top left hand corner of the wallplate, there must be

clearances of at least 15mm to the right, 15mm to the left, 30mm

above and 100mm below in order to mount the plug-in module.

Before mounting the unit ensure the 4 DIL switches on the

rear of the unit have been moved to the required settings (see

below). Factory preset is 7-day, with Optimum Start and Chrono-

proportional control OFF.

All models

5/2 day programming

Optimum start contoller enabled

Chrono-proportional control

TP7000, M, & RF models with 3/6 cycles per hour option

Chrono-proportional, 6 cycles / hour

NOTE

Use Chrono 3 for high thermal inertia systems, e.g. ﬂ oor standing cast iron

boilers.

Use Chrono 6 for low thermal inertia systems, e.g. low water content

boilers and combi boilers.

Danfoss Heating

7 day programming

Optimum start contoller disabled

On/Off control

Chrono-proportional, 3 cycles / hour

Tabla de Contenido