HP Autozubehor 20361 Instrucciones De Funcionamiento página 18

FEATURES
Please refer to fig.1 to familiarize yourself with the major components of this tool before
using it.
1. Bonne!
2. Spindle Lock
3. Switch Button
4.
Battery Pack
5. Charger
ASSEMBLY
CAUTION! Always be sure that the tool is switched oft before assembly, including
insertion or removal of the battery pack.
lnstalling or removing battery pack
1. To remove the battery pack, withdraw it from the tool while depressing the tabs on both
sides of the battery pack.
2. To insert the battery pack, align the ribs on the top of the battery with the grooves
in the housing and slide it into place. Always insert it all the way until it locks in place
with a little click. Lightly pull on the battery pack to ensure it is locked into place and will
not accidentally fall out of the drill, causing an injury.
3. Do not use force when inserting the battery pack. lf the battery does not slide in easily, it
is not being inserted correctly.
lnstalling the bonnet
1. Depress and hold down the spindle lock. To prevent damage to spindle or spindle lock,
always allow motor to come to a complete stop before engaging spindle lock.
2. Turn bannet in anti-clockwise direction.
5
10
15. Protect your hearing. Wear hearing protection during extended periods of operation.
Following this rule will reduce the risk of serious personal injury.
16. Battery tools do not have to be plugged into an electrical outlet; therefore, they are
always in operating condition. Be aware of possible hazards when not using your
battery tool or when ·changing accessories. Following this rule will reduce the risk of
electric shock, fire, or serious personal injury.
17. Do not place battery tools or their batteries near fire or heat. This will reduce the risk of
explosion and possibly injury.
18. Never use a battery that has been dropped or received a sharp blow. A damaged
battery is subject to explosion. Properly dispose of a dropped or damaged battery
immediately.
19. Batteries vent hydrogen gas and can explode in the presence of a source of ignition,
such as a pilot light. To reduce the risk of serious personal injury, never use any
cordless product in the presence of open flame. An exploded battery can propel debris
and chemicals. lf exposed, flush with water immediately.
20. Do not charge battery tool in a damp or wet location. Following this rule will reduce the
risk of electric shock.
21. For best results, your battery tool should be charged in a location where the
°
temperature is more than 50 F but less than 100
22. Under extreme usage or temperature conditions, battery leakage may occur. lf liquid
comes in contact with your skin, wash immediately with soap and water, then
with lemon juice or vinegar. lf liquid gets into your eyes, flush them with clean water for
at least 10 minutes, then seek immediate medical attention. Following this rule will
reduce the risk of serious personal injury.
SAFETY RULES FOR CHARGER
READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all
WARNING!
instructions listed below, may result in electric shock, fire and/or serious personal injury.
1. Before using battery charger, read all instructions and cautionary markings in this
°
F. Do not store outside or in vehicles.
neutralize.
7