Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1. Release the on/off switch when the switch button is not locked at "on" position. Or press at
the end of the switch button to make it spring back when the switch button is locked at "on"
position.
For Proper Operations
1. Before starting the grinder, put on safety glasses and make sure that the grinding wheel,
guard and the tool are in good condition and correctly fitted.
2. Always hold the tool firmly with one hand on the rear handle and the other on the side
handle.
3. Turn the angle grinder on and then apply the grinding wheel to the workpiece.
4: In general, keep the edge of the wheel at an angle of about 30
for finishing.
5. Move the grinder back and forth or up and down over the work area.
6. Use just enough pressure to keep the grinder from chattering or bouncing.
7. Avoid overloading the tool for a long time, heavy pressure will decrease its speed and put a
strain on the motor .
8. Lift the grinder away from the workpiece before turning your grinder off.
WARNING!
Never use your grinder without wearing eye protection. Following this rule will reduce the risk
of serious personal injury.
DANGER!
1.
Never attach a wood cutting or carving blade of any type to this angle grinder.
2.
Never use your grinder with guard removed.
3.
Failure to follow this rule could result in serious personal injury.
OVERLOAD PROTECTION
The power cutter is fitted with an overload/overheat protection device. When the tool is
forced to work at an excessive load,
the protection device will be activated automatically
°
for roughing and about 15
12
5.
Store idle tools out of reach of children and other untrained persons. Tools are
dangerous in the hands of untrained users.
When battery pack is not in use, keep it away from other metal objects like: paper clips,
coins, keys, nails, screws, or other small metal objects that can make a connection
from one terminal to another. Shorting the battery terminals together may cause sparks,
burns, or a fire.
7.
Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained tools
with sharp cutting edges are less likely to bind and are easier to control.
8.
Check for misalignment or binding of moving parts, breakage of parts, and any other
condition that may affect the tools operation. lf damaged, have the tool serviced before
°
using. Many accidents are caused by poorly maintained tools.
9.
Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may create a risk of injury when used on
another tool.
10. Keep the tool and its handle dry, clean and free from oil and grease. Always use a
clean cloth when cleaning. Never use brake fluids, gasoline, petroleum-based products,
or any streng solvents to clean your tool. Following this rule will reduce the risk of loss
of control and deterioration of the enclosure plastic.
SERVICE
1.
Tool service must be performed only by qualified repair personnel. Service or
maintenance performed by unqualified personnel may result in a risk of injury.
2.
When servicing a tool, use only identical replacement parts. Follow instructions in the
Maintenance section of this manual. Use of unauthorized parts or failure to follow
maintenance instructions may create a risk of injury.
1.
Always use proper guard with grinding wheel. A guard protects operator from broken
wheel fragments.
Accessories must be rated for at least the speed recommended on the tool warning
2.
SPECIFIC SAFETY RULES
5
Tabla de contenido
