Recommendations For A Proper Access To Model - Eco MODINE CGS 11EH3 Manual Tecnico

Recommendations for a proper access to model

Model with ø 200 mm fan motors
Access
1. Disconnect condensate drain connection so that it does not hamper with
opening/closing of fan shroud.
2. Loosen knurled fastening screws "F" and unscrew the fastening screws "C"
of the fan shroud.
3. Bring fan shroud to the position shown in drawing.
Remounting
1. Position fan shroud ensuring that the casing is inside, tighten knurled screws
"F" and fasten with screws "C".
2. Reconnect the condensate drain connection.
Model with ø 250 mm fan motors
Access
1. Disconnect drain connection and ensure that it does not hamper with the
handling of the fan shroud.
2. Unfasten screws "A" and "B" that secure the fan shroud to the casing and
carefully bring the fan shroud to the position shown in drawing.
3. Unfasten screws "C" and remove side panels.
4. To reach the heater positioned under the coil, remove drip tray secured with
screws "E".
5. In order open the heater terminal box (models ED and EDP), remove the
self-threaded screws "D" that fasten the right-hand side front cover.
6. For quick access to header side of coil, remove self-threaded screws "D"
that fasten the left-hand side front cover.
Remounting
1. Refasten drip tray with screws "E".
2. Place front covers back and fasten them with screws "D".
3. Refasten side panels with screws "C"
4. When closing the fan shroud it is necessary position the side panels inside,
subsequently fasten it with screws "A" and "B".
5. Reconnect condensate drain connection.
Model with ø 315 mm fan motors
Access
1. Disconnect drain connection and ensure that it does not hamper with the
handling of the fan shroud.
2. Loosen and remove fastening screws "A" of fan shroud to inner drip tray;
loosen and remove fastening screws "B" from inner side panel, remove baf-
fle and bring fan shroud to the position shown in drawing.
3. Loosen the self threading screws "D", without removing completely.
4. Loosen and remove self threading screws "D", then remove side panel.
Remounting
1. Reposition side panel and fasten with screws "C" and "D".
2. Return fan shroud to its original position ensuring that the side panels are
inside and fasten with screws "B".
3. Reposition baffle and fasten screws "A" to the inner drip tray.
4. Reconnect drain connection.
24
www modine com
Casing
Fan shroud
Side
panel
C
Inner drip tray
Fan shroud
A
Rear brackets
Baffle
Inner drip tray
Electric heater
Heater clip
Frontal
cover
E
B
Side panel
Inner side
panel
Fan shroud
D
Front
brackets