Making Coffee With A Preset Time - Beem MD-258BT Manual De Instrucciones

EN
Drip Stop
The device has a drip stop which prevents water from dripping out of the fi lter compartment (2)
when the thermal jug (6) is removed from the device.
When the device is in operation, the fi lter compartment must be closed and the thermal jug with
a lid placed on it must be placed beneath the fi lter compartment. The lid of the thermal jug pushes
the drip stop upwards and the coffee can fl ow from the permanent fi lter (8) through the lid into
the thermal jug.
During the brewing process, the thermal jug must not be removed for longer than 30
seconds from the main unit as otherwise the permanent fi lter could overfl ow.
Preparation
PLEASE NOTE!
• In the interest of your own safety, inspect the device and the connecting cable for damage
each time before you use it. Use the device only if it is in working order.
Do not operate the device without water or with less water than is required to reach the 4
•
Cups mark. If this does happen, the device switches off automatically. In this case, allow the
device to cool down before water is poured in and the device is used again.
• Never use the device without the thermal jug below the coffee outlet.
1. Prepare the coffee machine (see the "Handling and Operation" chapter).
2. Touch the fi eld ON/OFF (19) to start the brewing process. The display (3) shows the red
operating lamp (22) and the indicator for the chosen coffee strength (13). Hot water is now
poured over the coffee powder to brew it.
After the end of the brewing process, the red operating lamp and the indicator of the coffee
strength go out. The thermal jug (6) can now be removed.
If the brewing process is to be stopped prematurely, touch the fi eld ON/OFF twice. After
the fi rst time, the red operating lamp goes out and the brewing process is aborted, the blue
timer control lamp (16) lights up and the preset time is activated. After the fi eld is touched
for the second time, the timer control lamp and the selected coffee strength goes out. The
device is now switched off.

Making Coffee with a Preset Time

To make coffee with a preset time, the clock needs to be set (see the "Handling and Opera-
tion" chapter – "Setting the Time").
1. Prepare the coffee machine (see the "Handling and Operation" chapter).
2. Touch the fi eld PROG (18) twice. The display shows TIMER (12) and the preset time 12:00
(15).
3. Set the hours by repeatedly pressing the fi eld STD (hours) (21). If the fi elds are pressed for
an extended period, the fast increment mode is activated.
02442_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 24 02442_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 24
24
06.12.2019 11:35:01 06.12.2019 11:35:01