Vacuuming Dust; Steam Cleaning - Lavor ETNA 3000 Manual De Usuario

VACUUMING DUST

B
• Fit the most suitable accessory in the handle
of the fl exible hose L.
- Connect the device to a suitable electrical
outlet.
- Start vacuuming by pressing main switch B.
- To select the suction power (from level 1 to
level 4), press the remote suction button L
on the handgrip at short intervals; the se-
lected suction power level LED indicator will
light up. It is possible to change the power
level both when the suction is on and off . To
switch the vacuum on and off , hold down the
remote suction button L
onds.
16
L
1
L
1
for about two sec-
1

STEAM CLEANING

B
• Fit the most suitable accessory in the handle
of the fl exible hose L.
• Connect the device to a suitable electrical
outlet.
• Start vacuuming by pressing main switch B
• Turn on the steam system using switch E and
wait until "steam ready" light D lights up.
1
• For the outfl ow of the steam, press the lever
L
. The fi rst amount of steam will come out
3
with water condensation; direct the jet to
one side or onto a cloth.
- Pre-select the amount of steam using
the knob F located on the appliance. The
gauge R indicates the pressure inside the
boiler.
- To steam and vacuum simultaneously: it
is possible to use the above-mentioned
E
F
L
1
L
1
L
3
EN