Safety Instructions - Klarstein Hot Spot Crystal IR Manual De Instrucciones

EN
18

SAFETY INSTRUCTIONS

Read and follow all the instructions in this manual, even if you feel familiar with the unit.
Keep the instruction manual for future reference. When using an electrical device, the
safety instructions must be followed, including the following:
• Only use the voltage indicated on the nameplate of the heater.
• Do not obstruct the airflow at the air inlet or outlet in any way as the unit may
overheat and become a fire hazard.
• Do not cover the ventilation slots or the air inlets and outlets by placing the unit
against a surface. All objects must be at least 1 meter away from the front, sides,
and rear.
• Do not place the appliance near a heat source.
• Do not operate the unit in an environment where petrol, paint or other easily
flammable substances are stored.
• This equipment will become hot during use. Do not allow bare skin to touch the hot
surface.
• Switch off and allow to cool before moving.
• Do not use the appliance to dry laundry.
• Do not insert foreign objects or metal objects into the interior of the appliance or the
ventilation slots as this may result in electric shock, fire or damage to the appliance.
• Do not immerse the appliance in liquid or allow water to run inside as this may
result in electric shock.
• Do not operate the equipment with a damaged power cord, plug, or socket after
the equipment has malfunctioned, been dropped, or is damaged in any way. Refer
the product to an authorized electrician for inspection, electrical or mechanical
adjustment, maintenance, or repair.
• Do not operate the equipment with wet hands.
• The most common cause of overheating is the buildup of dust and lint on the
product. Ensure that these deposits are regularly removed by pulling the power plug
and vacuuming the air vents and grill.
• Always unplug the appliance before cleaning. Do not use abrasive cleaners for
cleaning. Clean with a damp (not wet) cloth that has only been dipped in soapy
water.
• Do not connect the appliance to the power supply until it has been fully assembled.
• The unit is not intended for outdoor use.
• Do not use the unit in the immediate vicinity of a bath, shower, swimming pool or
other liquid.
• Always operate in an upright position.
• Switch off and allow to cool before moving.
• Do not operate with a coiled cable as heat is highly likely to form and is sufficient to
constitute a hazard.