Resetting To The Factory Default Settings - Axis 212 PTZ Guia De Instalacion

Page 14
Accessing the AXIS 212 PTZ/AXIS 212 PTZ-V from the Internet
Once installed, your AXIS 212 PTZ/AXIS 212 PTZ-V is accessible on your local network
(LAN). To access the camera from the Internet, network routers must be configured to allow
incoming traffic, which is usually done on a specific port. Please refer to the documentation
for your router for further instructions.
For more information on this and other topics, please visit the Axis Support Web at
www.axis.com/techsup

Resetting to the Factory Default Settings

This will reset all parameters, including the IP address, to the Factory Default settings:
1. Disconnect power from the camera.
2. Press and hold the Control button and reconnect power.
3. Keep the control button pressed until the Status Indicator displays amber (this may take
up to 15 seconds).
4. Release the control button.
5. When the Status Indicator displays green (which can take up to 1 minute) the process is
complete and the camera has been reset.
6. Re-install AXIS 212 PTZ/AXIS 212 PTZ-V using one of the methods described in this
document.
More information
It is also possible to reset all parameters, except the IP parameters, to the original factory
settings via the web interface. For more information, please refer to the online help and the
user's manual. The AXIS 212 PTZ/AXIS 212 PTZ-V User's Manual is available from the Axis
Web site at www.axis.com or from the Axis Network Video Product CD.
AXIS 212 PTZ/ AXIS 212 PTZ-V Installation Guide