Installing Equipment - D-Link DFL-800 Guia De Instalacion

DFL-800/DFL-860 Default Interface Settings
Interface
Port Name Type IP Address
DHCP
WAN1
WAN1
0.0.0.0/0
Client
WAN2 WAN2 Static IP 192.168.120.254/24 Disabled
DMZ DMZ Static IP 172.17.100.254/24
Ports: LAN Static IP 192.168.1.1/24
1~7
Table 3. DFL-800/DFL-860 Default Interface
Assignment
Note: For security, D-Link NetDefend Firewalls
only allow Web GUI access from the LAN1 port by
default. That means the Web GUI access is only
allowed on LAN port labeled 1 of front plate by
default for DFL-800/DFL-860.
Installing and Connection
This section describes how to install a DFL-800/
DFL-860 device in a standard 11-inch equipment
rack and how to connect network and power
cables to the device.
Before You Begin
Observe the following precautions to help prevent
faults, equipment failures and injuries:
- Before installation, always disconnect the
power supply.
- Ensure that the room in which you operate the
device has adequate air circulation and that
the room temperature does not exceed 40˚C
(104˚F).
- Allow 1 meter (3 feet) of clear space from the
front and back of the device.
- Do not place the device in an equipment rack
frame that blocks the air vents on the sides of
the chassis. Ensure that enclosed racks have
fans and vented sides.
- Correct any of the following hazardous
conditions before any installation: moist or wet
floors, leaks, ungrounded/frayed power cables,
or missing safety grounds.

Installing Equipment

You can mount the DFL-800/DFL-860 device into
Web-Based
a standard 11-inch equipment rack. To install a
Mgmt
DFL-800/DFL-860 device into a rack:
Disabled
1. Attach the mounting brackets to each side of
the chassis as shown in Figure 3 and secure
Disabled
them with the provided screws.
Enabled
Figure 3. Attaching Rack Mount Brackets
2. Use the screws provided with the equipment rack
to mount the device in the rack.
Figure 4. Installation Using a Standard-sized
Connecting Power and Turning On/Off
The AC Power cord shipped with the device
connects the device to earth ground when
plugged an AC grounding-type power outlet. The
device must be connected to earth ground during
normal operation.
To connect power to the device, plug one end of
the AC power core into the AC power appliance
inlet on the back panel of the device. Plug the
other end into an AC power source.
Note: D-Link recommends the use of a surge
protector with your power connection.
Equipment Rack
D-Link NetDefend Firewall  3