Shutter Speed Setting (Shutter); Gain Control Setting (Agc) - Panasonic WV-CZ352 Instrucciones De Operación

(2) ALC Mode with BLC OFF
1. Move the cursor to BLC and select OFF. (When you select MANUAL, BLC is not avail-
able.) MASK SET appears on the menu.
2. To mask an area where backlight is bright, move the cursor to the area and press the
SET button. The mask turns white. Repeat this procedure to mask the desired areas.
Turns to white
3. To cancel a masked area, move the cursor to the area, and press the SET button. To
delete all the masking area, press the RIGHT and LEFT buttons at the same time for
more than 2 seconds.
4. After masking is completed, press the SET button more than 2 seconds. 48 mask areas
on the monitor screen disappear and the ALC CONT menu appears.

3 Shutter Speed Setting (SHUTTER)

In the AUTO mode, an object is clearly imaged under highlighted conditions by using
●
the combination technology of iris and shutter functions.
Note: When the selected shutter speed caused flicker on condition that fluorescent
lamps stay on, change this setting to "OFF".

4 Gain Control Setting (AGC)

Select ON (LOW), ON (MID), ON (HIGH) or OFF.
Notes:
Even if AGC is set to ON and if the noise reduction function is enabled, after images
●
may be produced by shooting a moving object.
For more information, refer to Digital Noise Reduction on page 20.
●
Blinking
Blinking
OFF (1/50) AUTO
1/10 000 1/4 000
1/120 1/250 1/500
1/2 000 1/1 000
17