C Ommissioning The Controller; C Alibrating The Speed Controller - df models KL-35 Manual De Instrucciones

4. c
ommissioning thE controllEr
Connect the controller to the motor, the
receiver, the servo and the battery as shown
in the image:
> Connect the three controller cables in any
sequence to the brushless motor (1).
Should the motor turn in the wrong direc-
tion, switch the connections of any two
controller cables with the motor.
> Connect the three-wire cable (black, red,
white) to the speed controller connection
(2) of the receiver (throttle, channel 2).
> Connect the steering servo (3) to channel
1 of the receiver.
> Connect the "+" channel (red) and the "-"
cable of the controller to the battery (4).
5. c
alibrating thE spEEd controllEr
The speed controller must be adjusted to the control lever travel of the remote control sender,
> if you are newly commissioning the speed controller,
> if your are commissioning a new speed controller,
> if you have changed parameters such as dual rate (servo path limiting), EPA (end point adjust-
ment) or neutral setting of the accelerator/brake lever on the remote control sender, or
> if you have reversed the motor's direction of rotation.
For this, the three lever setting "neutral", "full speed (forward)" and "braking/reverse" have
to be set.
2
3
-  -
4
1100_1101/V1/0110
1