Safety And Installation; Operator Safety - Techne BLoCKICE Manual Del Usuario

Ocultar thumbs

Contenido

página de 25

/ 25
Contenido
Tabla de contenido

Tabla de contenido

Please read all the information in this manual before using the BL

WARNING

Contact with low-temperature objects may cause cold burns. Users should be aware of the following

potential hazards:

• USE CARE AND WEAR PROTECTIVE GLOVES TO PROTECT HANDS

• DO NOT place any liquid directly into the instrument.

OPERATOR SAFETY

All operators of Techne equipment must have available the relevant literature needed to ensure their

safety. It is important that only suitably trained personnel operate this equipment, in accordance with the

instructions contained in this manual and with general safety standards and procedures. If the equipment

is used in a manner not specified by Bibby Scientific Ltd. the protection provided by the equipment to the

operator may be impaired.

All Techne instruments are designed to conform to international safety requirements and are ﬁ tted with

an over-temperature cut-out. If a safety problem should be encountered, switch off the unit at the mains

socket and remove the plug from the electricity supply.

INSTALLATION

The instrument should be carried using both hands. Never move or carry the instrument when in use or

connected to the mains electricity supply.

1. All Techne instruments are supplied with a power cable; this may be integral or plug-in.

2 .

Before connecting the instrument to the mains electricity supply, check the voltage

against the rating plate (located on the back of the unit). Please note that the unit

must be earthed to ensure proper electrical safety. Connect the mains cable to a

suitable plug according to the table below.

Connection

Live

Neutral

Earth

3. UK ONLY: The fused plug supplied with the mains cable is fitted with a 5 amp fuse to protect

the instrument and the operator.

4. The units are rated to operate at 100-230V, 50/60Hz.

5. Place the unit on a suitable flat bench or in a fume cupboard if required, ensuring that the air

vents on the rear and underside are free from obstruction.