Idiomas disponibles
Idiomas disponibles
INSTRUCTION SHEET FOR FEDERAL SIGNAL MICROSTAT
Failure to follow all safety precautions and instructions may result in property damage,
It is important to follow all instructions shipped with this product. This device is to be
installed by a trained electrician who is thoroughly familiar with the National Electrical
Code and will follow the NEC Guidelines as well as local codes.
This device may be considered a part of the signaling system and not the entire
signaling system.
The selection of the mounting location for the device, its controls and the routing of the
wiring is to be accomplished under the direction of the facilities engineer. In addition,
listed below are some other important safety instructions and precautions you
should follow:
• Read and understand all instructions before installing or operating this equipment.
• Do not connect this light to the system when power is on.
• After installation, ensure that all screws and threaded joints are properly tightened.
• After installation, test the light system to ensure that it is operating properly.
• After testing is complete, provide a copy of this instruction sheet to all
operating personnel.
• Establish a procedure to routinely check the light installation for integrity and
proper operation.
I. INSTALLATION.
A. Unpacking.
After unpacking the equipment, examine it for damage that may have occurred in
transit. If the equipment has been damaged, do not attempt to install or operate it.
File a claim immediately with the carrier stating the extent of the damage. Carefully
check all envelopes, shipping labels and tags before removing or destroying them.
B. Mounting.
1. Pipe Mounting.
The MicroStat
installed on machines, control boards, or any installation where pipe mounting is
required. If 1/2" pipe is used, a user-supplied reducer is required.
It is necessary to remove the base by disassembling the MSL unit. To remove the
base from the MicroStat
a. Remove the entire stack of colored lenses by twisting the very bottom lens
counter-clockwise (as viewed from the top) until it unlocks. Lift the bottom lens
upward and off the base unit. The other colored lenses should remain attached to
STATUS INDICATOR MODEL MSL
SAFETY NOTICES
serious injury, or death to you or others.
SAFETY MESSAGE TO INSTALLERS, USERS,
AND MAINTENANCE PERSONNEL
(MSL) is designed for installation on 3/4" NPT pipe. It may be
™
, perform the following steps (refer to Figure 1):
™
WARNING
-2-
™
