Using The Product As Intended; Contents As Delivered; Safety Notes - Marklin Digital 60940 Manual Del Usuario

Set de decoder retroequipable
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 87

Using the Product as Intended

The 60940 decoder is for converting Marklin locomotives
that appear on the following listing.
!
This decoder may only be used for the models listed below
or for all Märklin locomotives equipped with a 21-pin con-
nector and a blue decoder circuit board. If necessary, adjust
the value for CV 56 (see the following table). Trix locomotives
with a built-in sine motor cannot be converted. his decoder
may only be used for the models listed below or for all Märklin
locomotives equipped with a 21-pin connector and a blue
decoder circuit board. If necessary, adjust the value for CV 56
(see the following table).
Trix locomotives with a built-in sine motor cannot be converted.
Artikel:
CV 56
Artikel:
26557
24
37403
29440 (only E 10) 24
37404
31859
24
37435
31860
24
37436
37010
24
37485
37011
24
37502
37226
24
37530
37227
24
37542
37580
37239
24
37274
24
37581
37275
24
37786
37321
24
37867
You must do the following decoder settings on trains with a
pickup shoe changeover feature. These settings can only
be done in the mfx or DCC mode and are then also effective
CV 56
Artikel:
CV 56
24
39015
24
39025
24
39110
24
39123
24
39140
24
39343
24
39404
24
39441
24
39563
24
39564
24
39896
24
under fx (MM).
mfx: Call up the CVs, select a function not taken.
Call up "S" with the "+", select output 4, select direction of
travel "<", and store in memory. After that, call up "F" and
carry out programming as before. After that, the pickup shoe
changeover feature is activated.
DCC: Select the value 32 in CV 437 as well as CV 442 and
store in memory. After that the pickup changeover feature
is activated.

Contents as Delivered

1 decoder
1 speaker small
1 speaker big
1 Adhesive pad
0
Installation instructions
0
Warranty card
0
Tools also needed for the installation procedure include:
0
regular and cross-point screwdrivers, tweezers, and solder-
0
ing station with a maximum soldering temperature of up to
0
30 watts / 300˚Celsius / 572˚Fahrenheit with a fine tip, solder-
0
ing flux for electronics (0.5 - 1 mm / 0.02" – 0.04" diameter),
0
de-soldering braid or a de-soldering pump.
0

Safety Notes

0
0
• WARNING! Sharp edges and points required for operation.
• Do wiring and assembly work only on a voltage-free or
grounded work mat. Failure to do this can lead to danger-
ous static charge from your body and to damage to the
components.
UK
USA
21
loading