Idiomas disponibles
Idiomas disponibles
There are eight INPUT PORTS for PLUG-IN MODULES. Select the appropriate modules for each
I I n n p p u u t t C C o o n n n n e e c c t t i i o o n n s s
application. Plug the modules into the INPUT PORTS. Slide them between the card-edge guide
rails and secure them with the provided screws as shown in F F i i g g u u r r e e 3 3 . Ensure screws are
sufficiently tightened for proper grounding. For connection details, refer to the individual PLUG-
IN MODULE Instruction Guide.
CAUTION: Plug-in Modules should not be inserted or removed while the mixer/amplifier is turned
on. Cover unoccupied INPUT PORTS with provided blank panels and secure with screws.
Figure 3
L L o o u u d d s s p p e e a a k k e e r r O O u u t t p p u u t t C C o o n n n n e e c c t t i i o o n n s s
The loudspeaker outputs of the mixer/amplifier are 4 Ohms, 8 Ohms, 25V and 70V. C C o o n n n n e e c c t t t t h h e e
M M M M A A 8 8 1 1 5 5 0 0 2 2 ( ( 1 1 2 2 0 0 V V ) )
l l o o u u d d s s p p e e a a k k e e r r s s y y s s t t e e m m t t o o a a n n y y O O N N E E o o f f t t h h e e s s e e o o u u t t p p u u t t s s . . Class 2 wiring may be used.
There are two types of output: 4 Ohm Direct Output;
8 Ohm, 25V, and 70V via Output Transformer
The method of connection differs in each case. Refer to F F i i g g u u r r e e 4 4 . If using the transformer
isolated outputs be sure that the Low Cut switch is ON.
Note: Impedance values shown in Figure 4 indicate total loudspeaker system (load) impedance.
Figure 4
10
