Air Die-Grinder - Smarter tools 71PC Air Tool Kit Manual De Instrucciones

3.3 Impact Wrench
1. The Impact Wrench is designed to work with 1/2" drive sockets.
2. Before installing a socket onto the Wrench Anvil, make sure that the
tool's trigger is in the locked (OFF) position.
3. Slide socket onto anvil until it locks into place.
4. Place the socket on the bolt or nut that needs to tightened/loosened.
5. Hold the tool firmly with both hands, as torque will cause the tool to twist
when the trigger is depressed.
6. Gently squeeze the trigger to tighten or loosen bolt/nut. Apply additional
pressure on trigger as needed.
7. If the bolt/nut requires a higher level of torque than the tool can provide
at 90 PSI then an alternate tool should be used to achieve desired
torque. DO NOT attempt to raise air pressure to get more torque out of
the tool. Operating the tool at a higher than maximum rated pressure
can result in damage to the tool and/or accessory and possible injury to
the operator.

3.4 Air Die-Grinder

1. The Grinder attachment is designed to work with 1/4" grinder
accessories.
2. Before installing an accessory into the collet, make sure that the tool's
trigger is in the locked (OFF) position.
3. Select the accessory appropriate to your needs. Use one wrench to hold
the collet holder and the other wrench to open the collet nut.
4. Insert the shaft of the accessory into the open collet and use the
wrenches to tighten the collet nut.
5. Gently squeeze the trigger to start grinding before you touch the work
surface.
6. Allow the grinder to do the work. Apply additional pressure on trigger as
needed. DO NOT use excessive force against the surface you are
grinding. If you place too much pressure on the work-piece and the
grinder stalls, immediately release the trigger and pull the grinder away
from the work surface.
CAUTION:
TO PREVENT TOOL AND ACCESSORY FAILURE,
RESULTING IN INJURY: DO NOT EXCEED THE TOOL'S 90
PSI AIR PRESSURE RATING.
3-2