Smarter tools 71PC Air Tool Kit Manual De Instrucciones página 18

2. Attach an air hose to the compressor's air outlet (use of thread sealing
tape is recommended). Connect opposite end of the air hose to the air
inlet of the tool. Other components, such as a connector and quick
coupler will make operation more efficient, but are not required.
3. The air hose must be long enough to reach the work area with enough
extra length to allow free movement of the operator and the tool.
4. Make sure the tool's trigger is in the off position; refer to the "Operation"
section for description of controls.
5. Select the attachment (Grinder, Ratchet, or Drill) needed for the job and
fasten to tool body (see Operation section for instructions).
6. Close the in-line safety valve between the compressor and the tool.
7. Turn on the air compressor according to the manufacturer's directions
and allow it to build up pressure until it cycles off.
8. Adjust the air compressor's output regulator so that the air output is
enough to properly power the tool, but the output shall not exceed the
tool's maximum air pressure (90 PSI) at any time. Adjust the pressure
gradually, while checking the air output gauge to set the appropriate
pressure range.
9. Inspect the air connections for leaks. Repair any leaks found.
10. When the tool is not in use, detach it from the air supply and discharge
any residual air pressure with the trigger before setting the tool down.
Note:
Residual air pressure should not be present after the tool is
disconnected from the air supply. However it is a good safety
measure to attempt to discharge the tool in a safe fashion to
ensure that the tool is disconnected and unpowered.
Note:
Air flow, and therefore tool performance, can be hindered by
undersized air supply components.
2-4