Password Change; Dvr Functions; Manual Recording - urmet domus 1093/061S Guía Rápida

2.5.1

PASSWORD CHANGE

Use "◄►" to shift the "active frame" onto the "Password" box, press "Edit" and enter a new password.
The password is a maximum 16 number combination. To enter the sequence of numbers in a password, use the number keys
on the front of the panel (press "Edit" to cancel a character). The entered numbers will be replaced by a "*" symbol on the
screen for privacy.
After entering the password, press "Enter" to quit entry mode.
Use "◄►" to shift the "active frame" onto the "Verify" box, press "Edit" and enter the new password.
The password will be saved and become effective if the two passwords are the same.
An error message will appear indicating the fault if the entered password and the check password are different.
In this case, press "Enter" to go back to the previous menu and repeat the entry procedure.
IMPORTANT NOTE
•
Only numeric passwords if new users are programmed in local mode (i.e. using the front panel of the DVR).
Alphanumeric passwords may be created using the software.
•
It will not be possible to access the device in local mode (i.e. using the front panel) if an alphanumeric
password is chosen.
•
For safety reasons, the password is case-sensitive.
3

DVR FUNCTIONS

3.1

MANUAL RECORDING

Press "REC" on the front panel of the device in LIVE mode.
A password must be entered by default.
The following login window shown in the following figure will appear.
Pres s "◄ " to point the cursor to "Password" and th ►
Now , press "ENTER" twice to confirm and access the menu.
A sequenc e of three beeps lasting for approximately 3 seconds will be heard if the entered password is not correct. In this case,
pres s "MENU" and enter the password again.
IMPORT ANT NOTE
•
THE DEFAULT PASSWORD IS "12345".
•
It is advisable to change the default password to prevent int
•
To enter/edit the password, remember to press "SHIFT" (make sure that the STATUS LED lights up) followed
by the number keys. At the end of the operation, pre
LED will go out.
•
Do not lose or forget the programmed password.
•
Take note of the new password and keep it in a safe place.
•
It will not be possible to access the device in local mode (i.e. using the front panel) if an alphanumeric
password is chosen (using the dedicated software).
DS1093-022
Figure 30: password error message
Figure 31: login page
en use the number keys on the front panel to enter the default password.
ss "SHIFT" to go back to default functions. The STATUS
44
rusions.