Setting The Units - A&D Medical UC-352BLE Manual De Instrucciones

Turn the power of other Bluetooth devices off when performing pairing.
If measurement data cannot be received, try pairing again.
After pairing is complete, all communications are done automatically if the receiver is in the
receivable state.
In the unlikely event that this scale causes radio wave interference to another wireless station,
either change the location where the scale is used or stop using the scale immediately.

Setting the Units

1. Confirm that the scale is turned off, and
press the set switch.
2. Press the set switch to select the unit
that you want to set.
•The unit changes each time the set switch is
pressed.
•Wait for 3 seconds after setting the unit.
3. Confirm that "End" is displayed.
•The settings are saved.
•After three seconds of non-operation, the scale
confirms the selected unit with two beeps, displays
"End " and automatically turns off.
selected unit with two beeps, displays "End " and automatically
4. If you to wish to delete any readings stored in
memory press the set switch. Changing the units
format will delete any stored readings on the scale.
Note: to see readings stored in memory they must
be transferred to your mobile device and displayed
in the A&D Connect app.
Cautions for Pairing
®
E-8
Beep
lb
lb
kg
Beep beep