Kohler K-2268 Guía De Instalación Y Cuidado página 14

Installation – Above-Counter Lavatory
Mark and drill the anchor holes.
Marquer et percer les orifices d'ancrage.
Marque y taladre los orificios de anclaje.
Lag Screw
Vis à tête carrée
Tornillo de rosca para madera
Washer
Rondelle
Arandela
CAUTION: Risk of personal injury or product damage. Handle with care.
Product can break, chip, or cause injury if handled carelessly. Get help lifting the
lavatory.
NOTE: Two people are required for this lavatory installation. One is needed to
support the lavatory, while the other guides it and attaches the hardware.
Install the drain to the lavatory according to the fitting manufacturer's
instructions.
Temporarily position the lavatory in the cutout, and center it on the cabinet.
Ensure that the lavatory is level and that the drain is properly aligned. Adjust as
required.
Locate the two mounting slots on the underside of the lavatory basin, and mark
the hole locations on the finished wall. Also, trace the base outline of the lavatory
onto the cabinet top.
Carefully remove the lavatory.
Drill a 1/8" (3 mm) hole at each of the locations marked on the wall.
Apply a bead of adhesive sealant on the inside edge of the line traced on the
cabinet top.
Carefully position the lavatory, aligning the mounting slots with the drilled holes.
From underneath the lavatory, secure the lavatory to the wall with washers and
lag screws placed through the mounting slots. Do not overtighten the screws.
Remove any excess sealant.
1087250-2-C
Apply sealant
near the inside edge.
Appliquer de l'étanchéité
près du rebord intérieur.
Aplique sellador cerca
del filo interior.
14 Kohler Co.