Installing Terminal In A Panel - Allen-Bradley PanelView 550 Instrucciones De Instalación

Installing Terminal in a Panel

To install the PV500 terminal in a panel:
• Disconnect all electrical power from the panel before
ATTENTION
• Make sure the area around the panel cutout is clear.
• Take precautions so that metal cuttings do not enter any
• Failure to follow this warning may result in personal injury
1. Cut an opening in the panel using the panel cutout provided with the
terminal. Remove sharp edges or burrs.
2. Make sure the sealing gasket is properly positioned on the terminal (as
shown below). This gasket forms a compression type seal. Do not use
sealing compounds.
Legend Strip
Adhesive Tape
3. Verify that the ends of the legend strips are secured with the legend strip
adhesive.
4. Place the terminal in the panel cutout.
5. Make sure the ends of the legend inserts are positioned behind the panel
cutout.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
making the cutout.
components that may already be installed in panel.
or damage to the panel components.
Sealing Gasket
PanelView 550 Terminals 7
Publication 2711-IN009D-MU-P