For More Information; Hazardous Location Considerations - Allen-Bradley PanelView 550 Instrucciones De Instalación

2 PanelView 550 Terminals

For More Information

For
More detailed information on the 550 and the other
Standard PanelView terminals.
If you would like a publication, you can:
• download a free electronic version from the PanelBuilder32 installation CD
• download free from the internet: www.theautomationbookstore.com
To purchase a publication:
• visit the www.theautomationbookstore.com and place your order
• contact your local distributor or Rockwell Automation Representative

Hazardous Location Considerations

This equipment is suitable for use in Class I, Division 2, Groups A, B, C, D; Class II,
Division 2, Groups F and G; Class III Division 2; or non-hazardous locations only.
The following WARNING statement applies to use in hazardous locations.
EXPLOSION HAZARD
WARNING
• Substitution of components may impair suitability for Class
• Do not replace components or disconnect equipment
• Do not connect or disconnect components unless power
• This product must be installed in an enclosure. All cables
• All wiring must comply with N.E.C. article 501-4(b),
See the nameplate on terminal for hazardous locations certifications.
In Class I, Class II, Class III Division 2 Hazardous locations,
ATTENTION
the PanelView 550 terminal must be wired per the National
Electric Code as it applies to hazardous locations. Peripheral
equipment must also be suitable for the location in which it is
installed.
Publication 2711-IN009D-MU-P
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Refer to
Standard PanelView
Terminals User Manual
I, Class II, Class III Division 2.
unless power has been switched off or the area is known
to be non-hazardous.
has been switched off or the area is known to be
non-hazardous.
connected to the product must remain in the enclosure or
be protected by conduit or other means.
502-4(b), 503-3(b) as appropriate.
Refer to
2711-UM014