marklin Central Station 3 Manual Del Usario página 33

Calling up Track Settings
Here you can
shut off protocols
not being used.
Seeing IP Settings
Master-Slave Settings
Information Section
Sets all locomotives automat-
ically to the last known status
after restarting the CS3.
In the drop-down menu, you
can define the assignment for
the control knob in the World
of Operation mode.
This option is available when you connect
your Central Station 3 to your router with an
LAN cable. Here you have the choice whether
the CS3 is to obtain the necessary network
addresses from the router or whether you are
to enter the data manually.
This section takes on importance as soon as
more than one CS3 or CS3 plus is being used:
Here you set which CS3 is the main device
(Master) and whether this device is a secondary
or slave device.
The hardware and software version of your CS3
as well as legal information are shown in the
information section.
GFP3 – Data
The GFP3 (Track Format Processor 3) gives you information about the current measurement data for the layout
and the CS3. A wipe of your finger upward takes you to the lower sections of the page, including the settings
(images below).
Defines the time after Current voltage and
which the measured values temperature values for
are recorded again. the CS3.
GFP3 – Settings
S88 Bus: Setting the length,
cycle time, and bit time.
Electrical current present
currently in the main and
programming track.
Changing a
designation.
Selecting the
network in use:
Adjusting
the mode:
33