Tabla de contenido
Idiomas disponibles
Idiomas disponibles
much line has been fed out.
If too much line is fed out, remove the spool
cap and turn spool counter-clockwise until the
line is at the desired length.
To REmovE THE CAP (See Fig. F2)
•
Press and hold the two latches (9).
•
Pull cap away from the spool holder.
when refitting the spool cap, keep
•
all areas of the cap and spool holder
clean.
•
Replace the cap, pressing firmly down
towards the spool holder to ensure cap is
fully located into position.
•
Check that the cap is correctly fitted by
trying to remove it without depressing the
two latches.
REPlACE THE TRimmER liNE ANd
SPool (See Fig. G).
AlwAyS REmovE THE BATTERy
PACk BEFoRE AdJuSTiNG THE
TRimmER HEAd PoSiTioN
•
Remove Spool Cap Cover.
•
For your convenience it is recommended
12
you buy replacement spools with the
trimmer line preinstalled.
•
Remove the old Spool from Spool Holder.
Clear any broken line or cutting debris from
the spool area.
•
Pull the line from the new replacement
Spool through the eyelet of the Spool
Holder.
•
Place new Spool into the holder with the
cut out areas of the Spool facing inward or
down. when installed into the Spool
Holder, the smooth side of the Spool
should be visible.
•
Release line from cleat on the Spool.
•
Refit the Spool Cap Cover.
To mANuAlly wiNd liNE
(See Fig. H1-H4)
Take approximately 10ft (3m) of line. Insert
0.065"(1.65 mm) of line into the Spool holes
and wind line in the direction of the arrows on
the top of the Spool.
Leave approximately 4" (100mm) of line
unwound and place into the cleat.
Ensure that the line is neatly coiled on
10
Grass Trimmer/Edger
"
the Spool. Failure to do so will impair the
efficiency of the automatic line feed.
Then fit the Spool as described above in "Rep
lace the trimmer line and Spool"
STORING yOuR GRASS
TRImmER
Always remove the battery pack
from your trimmer after use.
Store in a dry place where the trimmer and
battery can be protected from damage.
mAINTENANCE
Always remove the battery pack
from your trimmer after use.
Always check the product prior to being used
for any damage.
Never operate your product if it is damaged.
Your power tool requires no additional
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never
use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep
all working controls free of dust.
EN
Tabla de contenido
Solución de problemas
