SentrySafe Fire-Safe Manual Del Dueño página 12

Bolt down instructions... continued
5
Move the safe aside to clear both marked spots for drilling.
6
7
Replace the safe in the desired position with the holes in the safe aligned with those
in the floor.
8
F
F F
NOTE: The safe should not be bolted to a wall, this will compromise the fire rating.
Drill holes through the feet only. Do not drill through the back or sides.
NOTE: Bolting/unbolting the unit is at a consumer's expense and discretion.
NOTE: Sentry Group is not responsible for any cost incurred if the unit has to be replaced.
For products that do not come with bolt down kits.
Go to www.sentrysafe.com to find recommended hardware and instructions.
Bolting Down Your Safe
For wood: Using the 9⁄32" (7.2 mm) drill bit, drill a hole
A
2-1⁄2" (64 mm) deep in each marked spot.
For masonry: Using the 3⁄8" (9.5 mm) drill bit, drill a
B
hole 2-1⁄2" (64 mm) deep in each marked spot. Install a
masonry anchor in each hole.
Securing the safe:
For wood: Pass each lag screw through a washer, then
A
through the safe and into a hole. Tighten with a wrench.
For masonry: Pass each lag screw through a washer,
B
then through the safe and into a masonry anchor. Tighten
with a wrench. Place masonry anchors into the holes
in the floor.
12