Special Functions - Medion MD 81035 Manual De Usuario

Incorporating delays
It can be useful to incorporate a time delay before a com
mand step in order to take the warm up phase of the TV set
into consideration, for example.
1. While entering the steps (see Point 6 above) press the
key (pause) at the spot where the time delay should
be incorporated.
2. Press a number key corresponding to the seconds by
which you would like to delay (e.g. "4" for a 4 second
delay). The maximum delay is 9 seconds.
Executing macros
1. To execute a macro, briefly press the MACRO key once
in the normal mode.
2. Then press the number key where the macro was saved
within 20 seconds (1, 2 or 3).
Deleting macros
1. Keep the SETUP key pressed down for approx. 3
seconds until the background lighting of the source key
will flash for a short time and then remain permanently
lit.
2. Press the MACRO key. The source key will extinguish
briefly.
3. Press the number key ("1", "2" or "3") of the stored
macro that you would like to delete.
4. Keep the SETUP key pressed down until the source
key extinguishes. The macro is now deleted.

Special functions

ALL OFF function
You can switch off all pre programmed devices at the same
time. This is done as follows:
1. Briefly press the ALL OFF key. The selected device
switches off and the relevant source key will light up.
2. Immediately press the ALL OFF key again and keep it
pressed down for 3 seconds. Now all pre programmed
devices will be switched off consecutively. This takes
about 3 seconds. The source key will extinguish after
wards.
Keep the remote control pointed at the devices to be opera
ted until the source key extinguishes.
Some devices can be switched on and off with the POWER
key. Devices switched off in such a way will be switched back
on after carrying out the ALL OFF function.
SLEEP – Programmed switch off
If your television has a sleep timer function you can call this
up by using the SLEEP button in the usual manner.
Programming the functions
Even if your television does not have this function, or the
programmed code does not support this function, you can
still programme an automatic shutdown after 1 to 99 minu
tes. Proceed as follows:
1. Keep the SETUP key pressed down for approx. 3
seconds until the background lighting of the source key
flashes for a short time and then remains permanently
lit. Press the SLEEP button.
10