Learn Function; Programming The Functions - Medion MD 81035 Manual De Usuario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 75

Learn function

You can manually save the functions of an original remote
control to your universal remote control. The universal re
mote control can "learn" up to 150 commands.
Notes on learn function
Use new batteries for both remote controls.
One original remote control can be saved to every source
key (8 in 1 function).
Once the memory is full, the background lighting of the
source key will flash for 3 seconds.
Programming each key can take approx. 3 seconds.
If you are programming an additional function to an exi
sting code, please take note which keys are still unassi
gned beforehand.
The following keys cannot be assigned to functions:
LEARN, SETUP, ALL OFF, MACRO and all source
keys.
Some original remote controls (for DVD, video recorder,
SAT) can themselves be programmed with the device co
des of some TV brands to carry out basic TV set functions
(volume, mute, channel search).
Do not attempt to transfer the functions of an original re
mote control that has been programmed with the code of
a different TV set to your universal remote control. This
could cause programming errors.
First try to program any type of command and then test it.
Then delete all commands (see "Deleting commands for
all source keys" on page 9) and begin with the actual pro
gramming.
Do not execute the learn function under a low energy
lamp. Such lamps (e.g. fluorescent lamps) can con
tain infrared light components that could influence
the learn function.

Programming the functions

To programme, proceed as follows:
Place the remote controls with the infrared diodes facing
each other spaced 15 to 50 mm apart on the table.
1. Keep the SETUP key pressed down for approx. 3
seconds, the background lighting of the source key will
flash for a short time and then remain permanently lit.
2. Briefly press the desired source key (TV, VCR, DVD,
ASAT, DSAT, CBL, CD, AUX) for this original remote
control.
3. Press the LEARN key.
4. Now press the key on the universal remote control that
is to be assigned to the relevant function (the source key
is permanently lit).
5. Now keep the key of your original remote control pres
sed down until the source key of the universal remote
control extinguishes once (each faulty programming will
be indicated by a flashing key).
6. Repeat steps 4 and 5 until all of the desired functions
have been saved.
7. Stop the programming by pressing the SETUP key.
8
Tabla de contenido

Solución de problemas

loading

Tabla de contenido