Recording With A Vcr (Video Recorder); Operating Combined Devices - Medion MD 81035 Manual De Usuario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 75
Activate the functions by pressing the corresponding
function key of your universal remote control. The source
key will light up briefly each time the key is pressed.
Please note:
In certain circumstances, not every function of your
original remote control may be directly available on
the universal remote control.
Especially for newer devices, it might be possible
that the functions are stored to different keys than ex
pected or may not even be available at all.
In these cases you can use the learn function to
transfer the functions of your original remote control
to the desired keys of the universal remote control
(see "Learn function" on page 8).

Recording with a VCR (video recorder)

The key
for recording to video recorder must be pressed
twice. This acts as a protection from accidental recordings.

Operating combined devices

Several controlling options are available to combined de
vices.
Combined devices with two device codes
Some combined devices (e.g. TV set with video recorder)
require two device codes one for each device part. The
combined device is then controlled like two separate de
vices.
Combined devices with one device code
Other combined devices only require one code. In this case,
you must first select the device part you would like to ope
rate.
Example: The device is a combined DVD recorder/video re
corder. The device code was stored on the DVD source key.
Now activate the DVD part in the combined device by hol
ding down the DVD source key for longer than one se
cond.
To activate the video recorder in the combined device,
first briefly press the SETUP key, then the DVD source
key.
If your combined unit only requires one code but you would
like to operate it with two source keys, then proceed as fol
lows:
Programme the device code to two source keys.
Operate one of the unit parts with one of the two source
keys.
Use the learn function (see next chapter) to transfer the
desired functions of the other unit part to the other
source key.
7
UK
Tabla de contenido

Solución de problemas

loading

Tabla de contenido