Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Pick a location which will allow you to blow the cold air
into the area you want. Windows used for installation
must be strong enough to support the weight of the air
conditioner. Good installation with special attention to the
proper position of the unit will lessen the chance that
service will be needed.
When cooling more than one room, installation location is
very important. If air conditioner is blocked by a storm
window frame, see step 16 on page 8 before beginning to
install. To cool your rooms, cold air must be blown from
the air conditioner in a straight path.
HOW TO INSTALL
H
Remove the screws which fasten the cabinet at
the back and side of the unit. Save side screws.
Discard back screws.
FIG. 3
I_11 Slide the unit out of the cabinet by gripping the
base pan handle and pull forward while bracing the
cabinet.
FIG. 4
I_Cut
the FOAM STRIP (ITEM J) to fit the
underside of the window sash. Peel off the backing
and attach the FOAM STRIP as shown in Fig. 5.
....
Sash
FIG. 5
L_ Insert the side curtain (ITEM A) into the upper guide
and lower guide of the air conditioner. Fasten the curtains
to the unit with screws (ITEM E).
Upper[g
FIG. 6
I_'_ Open the window. Mark a line on the center of the
window inner sill. Loosely attach the sill bracket (ITEM C)
to the support bracket (ITEM B) using the carriage bolt
(ITEM I) and the lock nut (ITEM D).
ITEM
ITEM I
r_
Attach the sill bracket to the window sill using the
screws (ITEM F). Carefully place the cabinet on the
window inner sill and align the center of the cabinet
front with the center line marked on the window inner
sill.
/Machine screw
Cabinet
,
/and locknut
trackhole
.Outer
_edge of
iT
windowsill
Carriagebott................
andlocknut
Sill bracket
FIG. 8
H
Using an M-screw (ITEM H) and a lock nut (ITEM
D), attach the support bracket to the cabinet track hole.
Use the first track hole after the sill bracket on the
outer edge of the window sill. Tighten the carriage bolt
and the lock nut. Be sure the cabinet slants downward
1/4" from level (FIG. 9).
CAUTION: Do not drill a hole in the bottom pan. The
unit is designed to operate with approximately 1/2" of
water in bottom pan.
Lowerguide
INDOOR
Cabinet
OUTDOOR
FIG. 9
-6-
Capítulos
Tabla de contenido
