Before You Call For Service - Alliance Laundry Systems SWD439C Guía De Uso Y Cuidado

Before You Call for Service

You may save time and money by checking the
following:
If the Washer:
Won't Won't
Fill Start
•
• •
• •
•
•
•
If the Dryer:
Does Does
Not Not
Start Heat
•
•
•
•
• •
(Electric Dryers
Only)
•
•
•
•
•
800938
Won't Won't Won't
Tumble Spin Drain
• •
• •
• •
• •
•
Does Not Dry
Clothes
Satisfactorily
Dryers equipped with power cord – Be sure the power cord is plugged all
the way into the electrical outlet.
Close the loading door.
Be sure timer is not in COOL DOWN setting or NO HEAT cycle.
Push timer knob in to start dryer.
Has the laundry room fuse(s) blown or become loosened, or are circuit
breakers open? The dryer itself does not have an electrical fuse. An
electric dryer has an electrical circuit with two fuses.
Has the motor overload protector cycled? Wait 10 minutes and try again.
Is the timer in a heat setting?
Gas Dryer Only – Check to see if equipment and main gas line valve is
turned on.
Check exhaust duct to outside to see if it is kinked, blocked or needs
•
cleaning.
Check weather hood to make sure flapper moves freely, has not been
•
pushed in or has not been blocked.
• Automatic Cycle – Adjust to more or less dry setting.
• Timed Cycle – Allow more or less time.
• Clean the lint filter.
• Is the load too small? Small loads may not tumble properly or dry evenly.
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Possible Reason
Be sure power cord is plugged all the way into the electrical
outlet.
Close the loading door tightly.
Check the house fuse or circuit breaker.
Turn on the hot and cold water faucets.
Pull timer knob out to start the washer. Check to make sure
timer is not set at an OFF position.
Clean the screens in the water mixing valve.
Are controls properly set?
Broken drive belt. Call the service person.
• Foreign object trap clogged. Call service person.
Possible Reason
Maintenance
Do This to Correct
–
Do This to Correct
–
25