Emerson Profibus Guia Del Usuario página 9

Soft starter status
The low byte data value of data request number 2 reports soft starter status.
Bits 0 to 3 function as follows:
Table 5-5 Status byte
Value (decimal)
Bits 0 to 3
0
1
2
3
4
5
6
1
7
1
8
1
9
1
Only available on Digistart IS soft starters.
Trip codes
Data request number 2 high byte indicates the soft starter trip or warning code. Details are as follows:
Table 5-6 Trip messages
Trip Code
1 Excess start time
2 Motor overload
3 Motor thermistor
4 Current imbalance
5 Frequency
6 Phase sequence
8 Power loss
11 Motor connection
12 Input A trip
13 FLC too high (FLC out of range)
14 Unsupported option (function not available in inside delta)
15 Starter communication (between module and soft starter)
16 Network communication (between module and network)
17 Internal fault
18 Overvoltage
19 Undervoltage
20 Ground fault
23 Parameter out of range
24 Input B trip
26 L1 phase loss
27 L2 phase loss
28 L3 phase loss
29 L1-T1 shorted
30 L2-T2 shorted
31 L3-T3 shorted
32 Motor 2 overload
33 Time-overcurrent (Bypass overload)
35 Battery/clock
36 Thermistor circuit
37 RTD/PT100 A
38 RTD/PT100 B
39 RTD/PT100 C
40 RTD/PT100 D
41 RTD/PT100 E
42 RTD/PT100 F
43 RTD/PT100 G
Profibus Module User Guide
Issue 1
Unknown (communication error between module and soft starter)
Ready to start (waiting)
Starting (soft starting)
Running (running – full voltage at the motor)
Stopping (soft stopping)
Not ready (restart or thermal delay and Run simulation)
Fault (tripped)
Menu or Logs Menu open (cannot start)
Jog Forward (slow speed)
Jog Reverse (slow speed)
Description
www.controltechniques.com
Soft Starter Status
Digistart CS Digistart IS
9