Connecting To The Water Supply Line; Installing The Water Line - Samsung RSG307 Serie Manual Del Usuario

Connecting to the water supply line

1. First, shut off the main water supply line and
turn the ice-maker off.
2. Locate the nearest cold, drinking water line.
3. After connecting the water supply with water
filter, turn on water supply and Flush 3 gallons
through filter before use (flush approximately 6
minutes).
Cold water Cold water
line line
Pipe clamp Pipe clamp
Shut off valve Shut off valve

INSTALLING THE WATER LINE

Connecting the water line to the
Refrigerator.
There are several items that you need to purchase
to complete this connection. You may fi nd these
items sold as a kit at your local hardware store.
• 1/4" compression nut
• copper tubing
Plastic Plastic
tubing tubing
(Assembled) (Assembled)
Ferrule (Not Ferrule (Not
supplied) supplied)
Copper tubing Copper tubing
(Not supplied) (Not supplied)
Household water supply line Household water supply line
DA68-02500A-11.indb 10 DA68-02500A-11.indb 10
Water line installation Water line installation
kit kit
• plastic tubing
• ferrule
Refrigerator Refrigerator
Compression Compression
nut (1/4") nut (1/4")
(Assembled) (Assembled)
Compression Compression
fitting fitting
(Assembled) (Assembled)
Molded Molded
end(Bulb) end(Bulb)
Compression Compression
nut (B) (1/4") nut (B) (1/4")
(Not supplied) (Not supplied)
Plastic tubing (B) Plastic tubing (B)
or or
(Not supplied) (Not supplied)
English - 10
1. Connect the household water line to the
assembled compression fitting.
- If you are using copper tubing, slip the
compression nut (B) (not included) and ferrule
(not included) on copper tubing (not included)
as shown.
- If you are using plastic tubing (B), insert the
molded end(Bulb) of the plastic tubing (B) into
the compression fitting.
Do not use without the molded end(Bulb)
of the plastic tubing (B).
CAUTION
2. Tighten the compression nut (B) onto the
compression fitting. Do not over-tighten the
compression nut (B).
3. Turn water on and check for any leakage.
Only connect the water line to a drinkable
water source.
If you have to repair or disassemble the
water line, cut off 1/4" of the plastic tubing
to make sure you get a snug, leak-free
connection.
BEFORE USING ICEMAKER
Remove
- Hold the handle as
shown in Figure1.
- Slightly pull up the
bottom part.
- Take out the ice bucket
slowly.
Install
- Assemble the icemaker
in the reverse order of
disassembly.
- Push the bucket in
firmly until you hear a
clicking sound.
- If the bucket does not fit into its place, turn
the gear handle on its back by 90 degrees
and reinstall it again as shown in Figure 2.
Figure 1 Figure 1
Figure 2 Figure 2
2013. 12. 2. 2013. 12. 2. 9:48 9:48