Ce Declaration Of Conformity - stayer CM230K Manual De Instrucciones

Ocultar thumbs

página de 28

/ 28
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

HOW TO USE THE RIP FENCE

Using the rip fence will provide more accurate straight cuts

than by cutting free-hand. For installation,

from power source

then insert the rip fence in the mounting

slots. In the base. See fig.9 Select the desired cut width on

the cutting guide and tighten the 2 thumb screws to lock.

LOWER RETRACTING BLADE GUARD

Is a safety device important for your protection. Every time

you use the saw, make sure that the guard rotates freely

and returns quickly and completely to its closed position.

Do not lubricate this area. The hub has a dry film lubricated

surface that does not need oiling. Never block or wedge the

blade guard in the open position. Never use your saw if the

blade guard is not in working order.

HOW TO USE THE TOOL

Next we detail the indications for a correct use of CM230K

There are 2 possible positions for the side handle:

on the blade cover or on the base. When making

bevel cuts, always use the base-mount position

because it it more stable.

Do not use this tool continuously over 30 minutes.

Wear safety glasses while using compressed air.

Do not use cutting fluids or lubricants on the blade.

Keep the cord away from cutting area to prevent it

from becoming entangled in the workpiece.

The workpiece should be straight and firmly

clamped. Clamp the workpiece on a rigid support.

Do not force the cut. Let the saw do the cutting at

the rate of speed permitted by the type of cut and

workpiece.

Periodically blow out all air passages with dry

compressed air.

Simply remove the brush caps and withdraw the

old brushes.

See fig.12.

(always replace as a pair). Then replace the brush

caps. The carbon brushes are a normal wearing

part and must be replaced when they reach their

wear limit (6 mm)

IMPORTANT

If the replacement of the power supply cord is

necessary, this has to be done by the manufacturer or

their agent in order to avoid a safety hazard.

disconnect tool

See fig.11

Replace with new brushes

See fig.13

ENGLISH