Tabla de contenido
Idiomas disponibles
Idiomas disponibles
they have reached their wear limit, the
motor will no longer run. Therefore if the
machine comes to a stop without any
apparent reason the brushes need to be
checked or replaced.
NOTE: Always replace the brushes as a pair.
To replace:
Remove the four screws and remove tail
cover Using pliers, rotate the brush spring out
of the way and slide the old carbon brush
out of the brush holder.
Remove the screw to remove the brush
lead. The old carbon brush many now be
lifted away.
To Install a new brush, Installation is the
reverse of removal.
NOTE: If yo u are mere ly che cking th e
brushes, always make sure that they go
back in the same way that they came out.
Otherwise a break-in period will occur that
w i l l r e d u c e m o t o r p e r f o r m a n c e a n d
increase commutator and brush wear.
Replace the motor tail cover.
ENGLISH
15
■ STANDARD ACCESSORIES
8mm hex wrench
6mm hex wrench
4mm hex wrench
■ If the replacement of the power supply
cord is necessary, this has to be done by the
manufacturer or their agent in order to
avoid a safety hazard.
DECLARATION OF CONFORMITY
We declare under our sole responsibility that
the product described under "T echnical Data" is
in conformity with the following standards or
standardization documents:
EN61000 according to the provisions of the directives
2006/42 CE,
2006/95CE and 2004/108CE.
15
IEC61029-2-10, EN55014,
Ramiro de la Fuente
Director Manager
Tabla de contenido
