2.2
De Entrada / Las Conexiones de salida
El Phaser-Strobe pbx tiene los gastos de la entrada y la produccion en
el lado izquierdo del estroboscopio. Estos pueden ser utilizados para
provocar o sincronizar externos (margarita que encadena dos o mas
luces estroboscopicas). Estos gatos aceptan 1/8" (phone 3.5mm) tapa
(de entrada-estereo, la produccion – mono). La entrada y la produccion
son TTL compatibles. Veal as figures 2 y 3 para el detalle de la conexion
del conector.
Señale la Entrada
+6V Fuera al
Sensor
Comun (GND)
Figura 2 Detalle de Entrada del Conector (Tapon Estereo)
Salida Pulso
Comun (GND)
Figura 3 Detalle de Salida del Conector (Mono Tapon)
La opcional ROS-P (Sensor Optico Remoto), la MT-190P (Magnético),
o IRS-P (Infrarrojo) sensores pueden ser utilizados también provocar
la unidad.
S-4
8.0 BATTERY
The Phaser-Strobe pbx is fitted with rechargeable NiMH (Nickel Metal
Hydride) batteries. These batteries contain fewer toxic metals than NiCd
(Nickel Cadmium) and are currently classified "environmentally friendly".
They also have 30% more capacity than NiCd batteries of the same size.
Like NiCds, NiMH batteries are prone to self-discharge - 10 to 15% of
charge is lost in the first 24 hours then continues at a rate of 0.5 to 1% per
Comun (GND)
day. For maximum performance, charge the batteries just prior to use.
When not in use, the batteries should be charged at least every three months,
+6V Fuera al
otherwise the battery capacity will be reduced or the batteries may become
Sensor
unusable.
Señale la Entrada
Charge the batteries before use and allow 3-5 cycles of charging and
discharging for batteries to reach full capacity.
The enclosure contains control electronics to properly and safely charge the
batteries. Never remove the batteries from the enclosure and attempt to
charge externally. Always use the charger supplied (PSC-pbxU).
Comun (GND)
Salida Pulso
AND
SPECIFICS
8.1
Low Battery Indication
When the batteries are charged, there will be no battery indication.
When the batteries are low, the Low Battery icon will blink in the
display. The strobe may still be used for a short time.
Low Battery Icon =
Outline blinking (very little time left)
The strobe has a protection feature that prevents the strobe from
operating if the battery voltage is too low. This condition is indicated
by no flash and the display shows "LO BAT". At this time the
POWER
SUPPLY
E-17
Capítulos
