Tabla de contenido
Idiomas disponibles
Idiomas disponibles
What to do if. . .
LIGHT DOES
NOT COME ON
LIGHT COMES ON FOR
ONLY A FEW SECONDS
LIGHT STAYS ON
OR
LIGHT COMES ON
RANDOMLY
Two-year limited warranty
Cooper Lighting, LLC ("the Company") warrants this product ("the product")
against defects in material or workmanship for a period of two yearsfrom date of
original purchase, and agrees to repair or, at the Company's option, replace a
defective product without charge for either replacement parts or labor during
such time. This does not include labor to remove or install fixtures.
This warranty is extended only to the original purchaser of the product.
A purchaser's receipt or other proof of date of original purchase acceptable to
the Company is required before warranty performance shall be rendered.
This warranty only covers product failure due to defects in materials or
workmanship which occurs in normal use. It does not cover the bulb or failure
of the product caused by accident, misuse, abuse, lack of reasonable care,
alteration, faulty installation, subjecting the product to any but the specified
electrical service or any other failure not resulting from defects in materials or
workmanship. Damage to the product caused by separately purchased,
non-Company brand replacement bulbs and corrosion or discoloration of
brass components are not covered by this warranty.
There are no express warranties except as described above.
THE COMPANY SHALL NOT BE LIABLE FOR INCIDENTAL, SPECIAL OR
CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THE
PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY. ALL
IMPLIED WARRANTIES, IF ANY, INCLUDING IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE
LIMITED IN DURATION TO THE DURATION OF THIS EXPRESS WARRANTY.
Call for customer service and/or missing or damaged parts (800-334-6871)
Is there power to the fixture?
• Has the house circuit breaker tripped?
• Is the wall switch ON?
Is the bulb(s) plugged or screwed in completely?
• Is the bulb(s) good?
(Be careful not to overtighten.)
Is the light sensor able to determine darkness?
• Cover light sensor with electrician's tape. Wait 2-3
minutes to see if light turns on. If it does, the sen-
sor is receiving too much light.
Is the wiring to the unit loose?
TURN OFF POWER BEFORE CHECKING.
Is the light sensor sensing reflected light?
• Cover light sensor with electrician's tape. Wait 2-3
minutes to see if light turns on. If it does, fixture is
receiving reflected light. Partially cover the light
sensor to block out the reflected light.
Is the light sensor in a shaded area?
• Shine a flashlight into the light sensor for 2-3
minutes. If the light turns off, the fixture is
mounted in an area that does not allow enough
light to enter the light sensor.
Is the light sensor good?
• Shine a flashlight into the light sensor for 2-3
minutes. If the light does not turn off, the light
sensor is bad. Contact customer service.
4
Tabla de contenido
