Manual Operation - Cooper Lighting FE13PC Serie Manual De Instrucciones

interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to cor-
rect the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Putting up your fixture
Step 1: TURN POWER OFF at main fuse/breaker.
Step 2: Mount crossbar (C) to outlet box (not included) using two of the
screws (F) provided. Either the #6 or #8 screws provided will fit most
standard junction boxes.
Step 3: Screw the threaded mounting tube (D) into the center of the
crossbar until there are threads showing on the back side of
the crossbar.
Wiring your fixture
Step 1: Connect the black fixture wire to
the black supply wire (hot). Secure
with a wire connector (E) (Fig. 1).
Step 2: Connect the white fixture wire to
the white supply wire (neutral).
Secure with a wire connector (E) (Fig. 1).
Step 3: Connect the green ground fixture wire to an appropriate supply
ground or a grounded junction box (E) (Fig. 1).
Note: Be careful to connect the wires correctly. Make sure no bare strands
of wire extend from the wire connector.
Step 4: Attach fixture to the threaded mounting tube (D).
Step 5: Secure with threaded mounting tube cap nut (D).
Step 6: Add silicone caulk around fixture to help maintain a weather-
resistant seal.
Installing the bulb
Step 1: Unscrew lens and remove from fixture.
Step 2: Line up the four pins on the base of the bulb with the four holes in the
mounting socket and slide into place.
Note: To remove old bulb, grasp the mounting end of the bulb and gently pull
the bulb away from the mounting socket.
Step 3: Replace lens.

Manual operation

You may choose to override the operation of the photo control and operate your
fixture manually from a wall switch.
Step 1: With a small standard screwdriver, gently pry out the clear photo
control cover (G) which is assembled in your fixture.
Step 2: Replace with the solid-color photo control cover.
Call for customer service and/or missing or damaged parts (800-334-6871)
3
Fig. 1