EGO ED0800 Manual Del Operador página 26

TRANSMISSION GEARS
LUBRICATION
The transmission gears in the gear case
need be lubricated periodically with gear
grease. Check the gear case grease level
about every 50 hours of operation by
removing the sealing screw on the side of
the case.
If no grease can be seen on the sides of
the gear, follow the steps below to fill with gear grease up to 3/4 capacity.
Do not completely fill the transmission gear case.
1. Stop the motor and remove the battery pack.
2. Position the edger upright so that the sealing screw is facing upwards (Fig. 21).
3. Use the multi-function wrench provided to loosen and remove the sealing screw.
4. Use a grease syringe (not included) to inject some grease into the screw hole; do
not exceed 3/4 capacity.
5. Tighten the sealing screw after injection.
CLEAN THE UNIT
◾
After each use, remove the battery and clean the debris, clogged soils or grass on
the blade and guard with a soft brush. Wipe the edger surface with a clean cloth
moistened with a mild soap solution.
◾
Use a small brush or a small vacuum cleaner to clean the air vents on the rear
housing.
◾
Keep the air vents free of obstructions.
STORING THE UNIT
◾
Remove the battery pack from the edger.
◾
Clean the tool thoroughly before storing it.
◾
Store the unit in a dry, well-ventilated area, locked-up or up high, out of the reach
of children. Do not store the unit on or adjacent to fertilizers, gasoline, or other
chemicals.
26
56V LITHIUM-ION CORDLESS EDGER — ED0800/ED0800-FC
21
Sealing Screw
Gear Case