Assembly - EGO ED0800 Manual Del Operador

ASSEMBLY

WARNING:
until the parts are replaced. Use of this product with damaged or missing parts could
result in serious personal injury.
WARNING:
recommended for use with this edger. Any such alteration or modification is misuse and
could result in a hazardous condition leading to possibly serious personal injury.
WARNING:
factory so that the arrow on the blade guard and the open side point away from the
operator. This ensures that cuttings and other debris are directed away from the power
tool and the operator.
UNPACKING
◾
This product requires assembly.
◾
Carefully remove the product and any accessories from the box.
◾
Inspect the tool carefully to make sure that no breakage or damage occurred
during shipping.
◾
Do not discard the packing material until you have carefully inspected and
satisfactorily operated the tool.
◾
If any parts are damaged or missing, please return the product to the place of
purchase.
MOUNTING AND ADJUSTING THE FRONT-ASSIST HANDLE
1. Remove the battery pack from the
edger.
2. Loosen the four screws in the
handle with the supplied hex
wrench and remove the screws and
the lower clamp from the
front-assist handle (Fig. 2).
14
56V LITHIUM-ION CORDLESS EDGER — ED0800/ED0800-FC
If any parts are damaged or missing, do not operate this product
Do not attempt to modify this product or create accessories not
Do not adjust the blade guard. The blade guard has been set at the
2
Screws
Lower Clamp
Front-Assist Handle